To locate center of hinge cup on back side of door, measure over from edge of door 22.5mm (7/8 ). Here drill a 35mm (13¼8 ) diameter by 13mm (1/2 ) deep hole. 2. Insert hinge into 35mm (13¼8 ) hole and position hinge so that the arm is perpendicular to edge of door.
Where do you drill holes for Blum hinges?
To locate center of hinge cup on back side of door, measure over from edge of door 22.5mm (7/8 ). Here drill a 35mm (13¼8 ) diameter by 13mm (1/2 ) deep hole. 2. Insert hinge into 35mm (13¼8 ) hole and position hinge so that the arm is perpendicular to edge of door.
How do you install an easy mount hinge?
Drill (2) holes 1⁄2″ deep with a 7⁄64″ drill at the top edge of the door as indicated in the illustration. Repeat the procedure at the bottom of the door. Mount the hinges on the door using (2) #6 x 5⁄8″ Phillips pan head screws per hinge. Tighten the screws just enough to hold the hinges in place.
What size screws Blum hinge?
Deep thread wood screws for attaching Blum hinges, mounting plates, and drawer slides. #6 x 5/8″ Flat head #2 Phillips screws are manufactured by Blum and sold in boxes of 100.
How do you install cabinet door hinges?
- Mark the Door and Place the Hinges.
- Adjust the Spacing Between the Hinges.
- Tape the Hinges in Place.
- Drive Screws on the Cabinet-Side of the Hinge.
- Glue the Door to the Hinge.
- Drive Screws on the Door-Side of the Hinge.
How do you adjust a Blum 170 hinge?
Mount the doors by clipping the hinge arms onto the mounting plates. All measurements are in millimeters. Turning this screw clockwise adjusts the door down; counterclockwise, up. Turning this screw clockwise adjusts the door inward; counterclockwise, outward.
How much adjustment do Blum hinges have?
There are 3 adjustments, in/out, up/down, and right/left. This allows for a perfect fit and alignment.
Do you need 2 soft close hinges per door?
In general one soft hinge is sufficient on majority of the door and closing habits. … However, if you close the door normally, or even with slightly harder manner than usual, one and two soft hinges would give you identical results.
How do you know what Blum hinge I have?
You will find the Blum logo on the TIP-ON ejector pin.
How do 270 degree hinges work?
This entertainment center hinge allows doors to open 270 degrees. The holes on the door side of the hinge and holes on the frame side of the hinge are elongated for adjustment. … The wrap around the back of the door is 1-3/8″.
Article first time published on
What is a 270 degree hinge?
270° pivot hinges allow total access to televisions, DVDs, VCRs and pullouts: Wrap-around design surface mounts to cabinet wall and 35mm door hole, bored at 13mm on center from the edge of the door. (Bored hole leaves an opening on the door edge.)
What is the angle of 270 degrees?
1.What is a 270 Degree Angle?5.FAQs on 270 Degree Angle
What are Blum screws?
For Blum products these screws are used to attach the rear fixing brackets and drawer bottoms.
What size screw euro hinge?
The #6 screw is for most European hinges and mounting plates.
