Let the tool cool down beforehand, and remove the battery and gas fuel cell.ONLY use official Paslode lubricating oil.Use official Paslode degreaser cleaner.Use a clean, lint-free cloth.Make sure you properly tighten all screws when reassembling the tool.
Can you use WD40 on paslode?
In addition, don’t use silicone spray and PTFE spray -they clog the whole thing and creates sticky spots. The other thing to steer clear of is WD40- this is a petroleum-based fluid and cannot work in a nailer because it wrecks the seals.
How often should I oil my nail gun?
Pneumatic Tools To break down deposits and ensure smooth starts and stops, most pneumatic nailers and staplers require a total of 4-5 drops of pneumatic tool oil into the air fitting every day, adjusting for the amount of use.
Why is my paslode not firing nails?
Possible causes for a Paslode nail gun not firing are: A nail jam is stopping the nails from moving forward. The gas fuel cell is empty, out-of-date or not attached properly. … The nailer needs cleaned – especially if it has been used a lot without regular cleaning!
How do you maintain a nail gun?
Regular cleaning can prevent dust, debris and other material from damaging or clogging the nail gun. After each use, wipe down the tool with a clean, soft rag. The air filter should also be removed and cleaned every few days if using the tool on a daily basis.
Why is my paslode charger flashing red and green?
If battery is completely discharged, the red and green lights may flash back and forth for up to 20 minutes. This safety feature slowly recharges the battery until it is ready to accept the full charging current. If the red and green light continue to flash after 20 minutes, replace the battery.
How often should you clean Paslode nail gun?
Paslode recommend that you clean and lubricate your nailer every 50,000 shots. If it’s being used in a dirty environment or at high nailing rates for extended periods of time then this should be more often. Cleaning your nail gun is easy and shouldn’t take any longer than 15 minutes.
How long does paslode gas last?
Part #816008Quantity1 PackSize1.32 oz.ColorOrangeMax. Shelf life27 Months
How does Paslode fuel cell work?
Cordless nail guns do not need an air compressor. Instead they use what Paslode calls a “fuel cell”. … When the trigger is pulled, a spark plug ignites the fuel charge, pushing the piston and connected drive pin to the bottom of the chamber and driving a nail.
How does a finish nailer work?
In a nutshell, a finish nailer is a nail gun designed for attaching finishing materials, like trim and crown molding, with finish nails. Like a brad nailer, a finish nailer uses headless nails. That means there isn’t much of a hole size left over when the nail is shot.
Article first time published on
Do nail guns need oil?
Traditional Oiled Nail Guns Oiled nailers require regular lubrication to ensure they function properly. Adding a few drops of oil into the air inlet each time you use the tool reduces heat and friction and prevents valves, seals and O-rings from wearing out. During heavy use, you should oil the tool more frequently.
Can I use WD40 on my nail gun?
A universal rule for protecting and prolonging the life of a pneumatic nailer, make sure to regularly oil your tool. … Never use WD40, motor oil, transmission fluid or aerosol lubricants.
Why is my nail gun just shooting air?
If you try to fire a pneumatic nail gun or stapler, but only hear air leaking when engaging the trigger, it’s likely that your tool’s “O-Ring” is not sealing properly. … Simply stretch the “O-Ring” on the firing valve and apply grease. This should take care of the issue – helping your air tool run properly.
What happens if I dont oil my nail gun?
The O-rings in the tool will dry up, causing the tool to malfunction. It will also cause unnecessary wear on its components, and potentially cause corrosion. To learn more about maintaining your nail gun, read our post on How to Avoid Destroying Your Pneumatic Nailer.
How do you clean a nail gun?
- Step 1: Remove Handle from Magazine and Clean Grill and Air Filter.
- Step 2: Degrease the Cylinder Head.
- Step 3: Lubricate Seal Rings.
- Step 4: Clean the Motor Assembly.
- Step 5: Oil the Motor Assembly.
- Step 6: Reassemble.
How long is paslode warranty?
all moulded nylon components on Paslode Impulse tools will be free from manufacturing defects in workmanship and materials for a period of 5 years from the date of purchase of the relevant product.
Can I use 3in1 oil in my nail gun?
A light weight non-detergent oil works well. If it has silicone in it , any exhaust may mess with coatings in the future, so stay away from that with items used in the wood shop. 3 in 1 works fine. Marvel works fine.
How much psi do I need for a framing nailer?
Framing Nail Gun Framing nail guns require the most air pressure because they typically use 3- to 3 1/2-inch nails that are driven into framing studs during the construction process of rough framing. Typical air pressures for this application range between 130 psi (pounds per square inch) and 100 psi.
How do I know my paslode battery is charging?
When you connect the charger to an AC outlet, the power light indicates that the device is on. When you mount the battery on the charger, the red light turns on, indicating the battery is charging. If the power or charger light doesn’t come on, the charger is most likely faulty.
How long do paslode batteries take to charge?
This Paslode Lithium Battery Cell is a great power tool accessory. It takes 90 minutes to fully charge. It can be used with a Paslode Framing Nailer, Paslode Gas Brad Nailer, Paslode Impulse Angled Nailer and a Paslode Gas Posit Placement Nailer.
Why does paslode use gas and battery?
Gas-Powered Cordless Nail Guns These types of nailers were designed to mimic pneumatic nail guns, by using compressed gas fuel in combination with a battery. … The combination of fuel and air forces the piston and the driver blade downward, which fires the fasteners. The first tool of this kind was invented by Paslode.
Is paslode a good brand?
Paslode Brand They are reliable and durable products and are constantly evolving with changes in technology to meet modern building needs. The company offers a wide variety of guns from which to choose. They specialize in both the guns and the accessories, such as the quality fuels and nails that work with each model.
How many nails are in a paslode strip?
When you buy a fastener pack they contain 2500 nails and, yes, they give two fuel cells with it. The nails are paper-collated and at an angle (34˚), and come in three different coatings/finishes: bright, hot dip galvanised, and mechanically galvanised – all with diamond points.
Does nail gun gas go off?
There is an expiration date on the fuel cell. They may work if expired or they may not. … If you do not use very often don’t buy spare fuel cells, it can be a waste of money, the gas will go bad eventually.
