How do you remove Thetford toilet seat

Lower the seat and locate the two screw covers at the back of the seat. … Put the flat-head screwdriver in the screw slot and hold it steady while you unscrew the nut from underneath the bowl. … Remove the nut and bolt and take the seat off the bowl. … Insert the screw back in the holes.

How do you remove a sliding toilet seat?

Lower the seat and locate the two screw covers at the back of the seat. …
Put the flat-head screwdriver in the screw slot and hold it steady while you unscrew the nut from underneath the bowl. …
Remove the nut and bolt and take the seat off the bowl. …
Insert the screw back in the holes.

How do you remove a quick release toilet seat?

Most modern toilet seats will have a quick release button to help you take it on and off easily. Press the button and lift the seat up. With a screwdriver, lift up the seat fixing caps to get to the bolts underneath. With your screwdriver, unscrew both of the bolts.

Does a Thetford toilet come apart?

Secondly, the flush tank does NOT come out, it is an integral part of the toilet moulding. Third, on the flush/operating knob, once you prise the centre disc up you will need a long reach phillips screwdriver to undo the screw in the base of the knob and connects to the blade mechanism and microswitches.

How do you remove a hard toilet seat?

Remove all the bolts and nuts and then lift the seat off the bowl. Place all of this in the plastic bag, seal it and dispose. If the seat is attached with a traditional metal bolt and metal nut, grab your socket wrench and fit it over the long bolt that grips the nut. Turn the nut counterclockwise to loosen.

How do you get a stuck plastic nut off a toilet seat?

If the nut won’t budge, douse it with a penetrating spray lubricant such as WD-40. Hold a rag behind the nut to catch the overspray. Give the lubricant 15 minutes to penetrate, then try again. If the bolt spins as you turn the nut and doesn’t loosen, or the bolt just spins, go to the next option.

How do you remove a rubber nut from a toilet seat?

Removing Older Toilet Seats Simply unscrew the nut from the attached bolt. Corroded bolts and nuts are harder to detach. To remove the nut from the seat hinge bolt, use a long socket and socket wrench to unscrew the nut. If the nut will not budge, you may need to cut the bolt off.

Can you replace an RV toilet with a composting toilet?

In these cases, it may need to be switched out for another model. If it’s a matter of an uncomfortable toilet seat, many RV toilet seats can be removed and replaced with a more comfortable style. … Some RVers prefer to switch out their flush toilets for a composting toilet.

How do you remove a plastic bolt from a stripped toilet seat?

Place the end of a putty knife against the screw at the bottom of the toilet, above the plastic nut. Tap the end of the putty knife with a hammer, digging the knife into the screw. Continue tapping until the putty knife cuts through the screw, then lift up the seat and screws.

How do you remove Thetford C2 cassette toilet?

If your caravan is teh Thetford C2 then there will be two screws securing it to the floor. Open the outer door, remove cassette, unscrew the two screws. Then go into the shower cubicle and lift the entire unit vertically.

Article first time published on

Where is the model number on a Thetford RV toilet?

Using the data sticker to identify your Thetford toilet model. If you are not sure which model toilet you have, you will find a data sticker attached to the base of the toilet beneath the waste holding tank. The model number will be printed at the beginning above the barcode – as shown below.