Step 1: Position the lawn mower. … Step 2: Check the petrol level. … Step 3: Check the oil level. … Step 4: Check the spark plug. … Step 5: Press the fuel button 3 to 5 times. … Step 6: Put the throttle in the start position. … Step 7: Pull the starter rope. … Step 8: Lawn mowing!
How do you start a lawn mower step by step?
- Step 1: Position the lawn mower. …
- Step 2: Check the petrol level. …
- Step 3: Check the oil level. …
- Step 4: Check the spark plug. …
- Step 5: Press the fuel button 3 to 5 times. …
- Step 6: Put the throttle in the start position. …
- Step 7: Pull the starter rope. …
- Step 8: Lawn mowing!
Why is my lawn mower turning over but not starting?
The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.
How do you adjust the deck on a Poulan Pro riding mower?
Hold onto the lever and push down on the button on top with your thumb. Pull the lever toward the back (rear side) of the mower to raise the deck height. Push the lever forward (front side) to lower the deck height. Observe the height adjustment indicator at the bottom of the lever for height settings.
Why won't my riding lawn mower go forward?
Clogged Fuel/Air Filters A blocked fuel filter can keep gasoline from flowing to your mower’s engine in adequate supply, resulting in a lawn mower that isn’t drivable. Damaged or clogged air filters also can prevent your lawn mower from going forward or in reverse simply because the engine will overheat quickly.
Why is it so hard to start my lawn mower?
The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. … This sticky fuel can clog up the fuel filter and make the engine hard to start. If old fuel was left in the lawn mower, drain the old fuel from the fuel tank and replace the fuel filter.
Where is the choke lever on a lawn mower?
There’s a variety of lawn mowers, but for an internal combustion engine, the choke valve is usually located on the body of the engine or a lever on the handle. Most choke valves are butterfly valves mounted in the manifold up from the carburetor jet.
How do you start a choke on a riding lawn mower?
- Sit firmly on the seat.
- Start the Engine.
- Press the Brakes.
- Engage the Parking Brake.
- Put the Gear to Neutral.
- Pull the Throttle onto Choke Position.
- Insert the Ignition Key.
- Turn the Key to the Right hand side/Clockwise.
How do I start my lawn mower with a choke?
Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.
How do you adjust the belt tension on a Poulan riding lawn mower?
- Roll the Poulan riding mower onto a flat surface. …
- Lift the cover for the engine and remove the spark plug, using a socket wrench. …
- Lower the mower deck.
- Push in on the idler pulley underneath the engine. …
- Remove the bolt from the housing on the deck.
Article first time published on
What height should a lawn mower be set at?
The top setting for most mowers gives a cutting height between 3.25 and 4 inches. This is best for your lawn, but at a setting of 4 inches you may sometimes see some “laying-over” of turf blades that some people find undesirable. For this reason, some people prefer to mow at 3 or 3.5 inches.
Why does my lawn mower only run for a few seconds then dies?
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that’s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
Where is the spark plug on a mower?
Spark plugs are typically located on the back or side of a lawn mower engine. Look for a short wire that’s about 1/4-in. -thick leading to the top of a short, cylindrical protrusion from the engine. If you’re not sure where the spark plug is, consult your owner’s manual.
What kind of oil does a Poulan lawn mower use?
Poulan Pro uses Briggs and Stratton engines in its products. On its website, Briggs and Stratton recommends using a high-quality detergent oil based on the temperatures in your climate. Engine oil products labeled as “SAE 30″ work in temperatures above 40 degrees Fahrenheit but are not meant for cold conditions.
Should I drain oil from lawn mower for winter?
If you want to keep your mower in great condition (and make sure it starts first time in the spring), you need to winterize it properly. This involves cleaning it, draining it of any oil and gas or removing the battery, and making sure all the parts are free from debris and ready for storage.
Why is my mower not moving?
If your riding lawn mower won’t move, the problem could be a broken ground drive belt. If the riding mower is slow and sluggish, the ground drive belt could be so worn that it slips. Either way, follow the steps in this repair guide and video to replace the ground drive belt on your lawn tractor.
How do I engage my riding lawn mower?
- Turn the key to the “on” position, advance the throttle to half speed and allow the engine to warm up for 2 minutes. …
- Lower the mower to the desired cutting height. …
- Engage the mower blades; push the lever to the right of the steering wheel all the way forward.
What does the drive belt do on a riding mower?
The ground drive belt connects the engine crankshaft to the transaxle pulley to drive the rear wheels. If the belt breaks, the lawn tractor won’t move. If the belt is worn, the lawn tractor moves sluggishly because the belt slips on the pulley.
How does a lawnmower choke work?
By restricting the flow of air into the throat of the carburetor, the choke valve reduces the pressure inside the throat, which causes a proportionally greater amount of fuel to be pushed from the main jet into the combustion chamber during cold-running operation.
Is there a choke on a push mower?
The Function of a choke or priming bulb is to enrich the fuel mixture, so a cold engine starts smoothly. Gas engines run best when the ratio of air to fuel is 14.7 to 1. Meaning 14.7 parts air to 1 part fuel, also known as an air-fuel ratio (AFR). … Some mowers use a snowflake symbol for the choke.
What does the lever on a lawn mower do?
A lever, or auger, attached to the handle is a common type of deadman control on walk-behind consumer lawn mowers. The lever must be held down in order to start the mower and to keep it running. The lever is spring-loaded, returning it to its “off” position when pressure is released.
How do I start my lawn mower after winter?
- Check the oil before you start a four-cycle mower that has been sitting for a long time. …
- Prime the engine by pushing the priming bulb three times. …
- Give the spark plug wire a little tug to see if it’s loose.
How do you start a lawn mower without a primer bulb?
In order to start your mower without a primer, squirt starter fluid directly into the carburetor via the air intake. Simply remove the air filter cover, take out the air filter, and squirt starting fluid into the air intake nozzle. Quickly replace the air filter, and start your mower. It should start straight away.
How many pulls should it take to start a lawn mower?
A lawn mower should take between three to four pulls to start. Push the mower a few times to get the wheels turning, then pull the handle quick and far back. Pulling it at the proper distance and speed is crucial for getting it to start as soon as possible.
What is the difference between a deck belt and a drive belt?
So, with the mower deck removed from the tractor, the “drive belt” would be the one still on the tractor. The mower deck itself will still have the internal “deck belt” which if you turn one blade by hand, all blades turn because that deck belt is what connects and drives all the blades together.
